2020 defender headlight swap to led

[Hammes357]

wanting to change the factory headlight bulbs to led. What's a good plug in play set to get? I seen some different topics on this but they was from a year or two ago so i was just checking with a new updated thread. And if anybody has a good set of brake pads they switched to so you don't have the factory squeaking that will drive you nuts, let me know.

 

[Steelslinger]

Beamtech H11 fanless. Should be about $35usd on amazon. Two sets, hi and low beams.

 

[Hammes357]

thanks!!!!

 

[Bad Daddy]

Steelslinger, can you send me the link to the Beantech lights you purchased ?

I show a few that are fabless, but not sure which ones will work- none of them say they’ll fit the 2020 Defender, lol. 
 

Thanks,

BD

 

[Steelslinger]

None of them will say they fit Can-Am Defenders because its a niche market and the manufacturers don't list everything they will work on due to liability. But anything with H11 designation will work as that is an industry standard for bulb/connectors. 

https://www.amazon.com/BEAMTECH-Headlight-Fanless-Extremely-Conversion/dp/B072JC755L/ref=sr_1_1_sspa?dchild=1&keywords=beamtech+h11+led+headlight+bulb&qid=1635965628&sprefix=beamtech%2Caps%2C222&sr=8-1-spons&psc=1&spLa=ZW5jcnlwdGVkUXVhbGlmaWVyPUEyMzdIWlI3SUI5UEhFJmVuY3J5cHRlZElkPUEwOTc3ODU0MVUzV0ZaN1c4WlZKMCZlbmNyeXB0ZWRBZElkPUEwMzcwMDY5Mkw2NE9KV0ZTWkJSOSZ3aWRnZXROYW1lPXNwX2F0ZiZhY3Rpb249Y2xpY2tSZWRpcmVjdCZkb05vdExvZ0NsaWNrPXRydWU=

 

[Bad Daddy]

I got them and did the install. bought two sets, did low beams for now, will put on highs once I am satisfied there are no issues. 
 

I found them to move around a bit in the housing, likely due to the gasket size and the weight of the heat sink.  Hopefully they are water tight!

Thanks again for the link!