Recent content by Steve

Ok. Thanks for the info Mark. Queen Creek is where we have our primary home out east of Phx. Will have to check on that many acres. We are surrounded by national forest so I'm not sure if many large parcels around here. But will check.

Our cabin is actually in a community called Ponderosa Springs, about 8 miles east of Christopher Creek. Just below Forest Lakes and the rim. My wife is actually a part time realtor, mostly for friends, family and repeat clients.. But she says there is a lot of inventory right now. This is the...

Hey Mark. We started spending the summers up here since covid in 2020. We built up here in 2013 and at an elevation of 6400 ft it is 20 deg cooler than Phoenix in the summer. Definitely beats 115 in Phx anytime.  We have good trout fishing up here too. Have you been thru this area of AZ before...

Well, I'm almost embarrassed to post our 2019 Lone Star mileage and hours, but since I have company, here goes. 50.4 hrs and 462.9 miles. We use ours mostly around our cabin located near Christopher Creek AZ. 

Looks sharp.

Thanks for the update.

One thing I do is prime the fuel system 3 times before I try to start in cold weather. Does it fire then stall? Or do you have to crank it a lot before it fires up?

I also installed the Beamtech H11 in our 2019 Lonestar. Made a huge difference.

Have you tried any local dealers for takeoff tires and wheels. i was lucky enough to get good deal on a wheel and tire combo takeoff for our Lonestar at a local dealer here in AZ. You can also try Craigslist.

Hello Shelfish. Check out Canampartsguy.com for the plastic rivets. They sell a pack of 25 for $11. 

Yep, makes a big difference. I did my defender 2 yrs ago. Glad I did.

Welcome. Can you hear the fuel pump run when you turn the key to ON? How much fuel in the tank?

Steelslinger, I have a 2006 Polaris Ranger 6x6 that I have the plow on and is our workhorse here at the cabin. I save the much nice 2019 Lonestar for cruising around and trail riding and exploring the forest roads. I am looking at both a power lift and power angle setup using linear actuators...

Nice metal work Steel. You gave me some good ideas to tackle the plow on one of my machines. Thanks.

Why not just use a 12v air compressor? Do you air down your tires when off road?