Recent content by RossO

Is the HD10 Limited still available? I was browsing online and noticed there are no options to purchase an HD10 Limited.

Gotcha. Sounds like you are right about the draw. Unfortunately I am zero help with knowing what could be the parasitic draw, but I also think adding the second battery kit will help. From what I've heard most of your accessories run off of that battery and are completely separate from the...

It kind of sounds like your battery is going dead while you're plowing and not when its parked. I am by no means a mechanic, but if your are using your stereo, lights, seat warmer and winch all at the same time, you might be drawing more power than the stock stator can replace... Especially if...

I appreciate all the responses. I was in Waubay SD with temps around -26 on Friday morning. I was able to keep my machine in an enclosed trailer at night with a little electric space heater which didn't do much, but I think it helped big time. There was another defender that was in a...

Alright all, I'm headed out ice fishing with my Defender this weekend and the temps are going to be colder than I'd like (-11F for a high and -23F for a low), but the show must go on. What are some things to do for prep or things to bring to make sure the machine gets us off the ice?

I didn't buy the SDI shocks, but I did buy the Fox QS3 shocks and it completely changed the way it rode. They were $2,700ish from Shock Therapy. My justification was that I could take them off and move them to a different machine if I buy a different one and I could have them rebuilt when they...

Would this help to mount a Ram mount to?

You'll get the factory ride back, lose about 3 inches of ground clearance and the cv joints on your axles will thank you.

I wouldn't waste your money on factory half doors unless you have zero plans to go to a full door.  I went with the Puddle Buster doors that are convertible between half and full.  They are not perfect, but they are one of the cheaper doors and one of the only doors that can be both a half and...

Does anyone know if camso tracks will work with Rhino 2.0 axles?  When I installed the tracks with a lift and I noticed that the front mounting plate bolts were very close to the CV joint.  I heard that the CV joint on the Rhino 2.0 axles is bigger in diameter so I'm curious if they will work. ...

I just installed the Fox QS3 shocks on my 2018 Xmr and if anyone is on the fence about upgrading to new shocks, DO IT!  It raised the machine 2in from factory and it feels like a completely different machine when driving down roads and trails.  The ride is 100% better.  Way less...

I ordered them off of amazon.  They are made to fit perfectly on the roll cage, but I had to install rivet nuts in the roll cage to be able to bolt in on.

The red and black is your power for the dome light (a can am dome light plugs right into these) and the purple and white is for the windshield washer fluid pump that mounts on the washer fluid tank right behind the cab.   Red set should be constant when the ignition is on and the purple set is...

In my opinion these engines are tuned down quite a bit, so, I'd say you are completely fine.

I believe that is a diagnostic plug.  It should be plugged into the piece of plastic on the top right of the picture.