Recent content by Hammes357

same here with my hd 10 2020

so after further review it wasn't my water pump it was that stupid plastic water neck again but it was leaking on the backside which i didn't see until i took my passenger seat out and middle section to open access panel up. i put the aluminum water neck on and new gasket, so far so good fingers...

lost a roll pin out of my seat when i had them apart and i still have no clue where that went but anyway the part number is 708001903, but my question is could a guy just use a piece of 1/2 emt or something like that instead? i know the part is 3.49 plus probably 20 to ship it but has anybody...

Found another new leak on mine, i think its coming out of the weep hole on my water pump but ill get my belly pans off this weekend and go from there. Always something lol!

if your talking about the plastic waternecks that can am uses i have replaced mine behind the firewall 3 times now on my 2020. the bad part is the gaskets cost more than the plastic waterneck. But i did find a place that makes aluminum ones for the defenders and will defiantly be going to them...

inserting thread because i want to change my factory ones also because they seem a hell of a lot rougher than they used to be and i haven't changed any settings on them since i bought it new 

so not much has changed again for this year?

update on mine after service work. Had to return it 3 months later doing same thing so of course out of warranty so they put some red oil in it and it worked fine for another 2 months but now doing the same thing and now my steering wheel locks up all the time on the city streets but not on...

Since we’re on clutch issues here my 2020 is just starting to act like it’s wants to shift into a lower gear when I’m slowing down to make a stop and it's never done that before. Any ideas?

So are the inferno heaters good or mid card? Because I have read both on reviews. Looking for something for my 2020 single cab

interesting to say the least!

4 bolts hold the whole drivers seat in. take them out then the whole seat comes out then you can easily take the torx screws out. it takes a little bit to get the back 2 bolts out of the bottom seat but not bad.

four bolts hold the drivers seat in place and two set screws hold the back part of the seat on. took a little bit but i got it

ok i see the torx for the back seat on the drivers side but how does the drivers bottom seat come off? i am putting seat covers on also. i see that it has bolts in it but it almost looks like the whole seat frame comes out?

i did go with the  KEMIMOTO UTV Seat Covers off of amazon pretty simple for install and look pretty good. will see hoe they last with dogs. Now back to the install i have all the seats done but the drivers side because i have no clue how those seats come off since it looks like it all comes out...