Recent content by Dillmania

I will add an anchor point at the door handle today.  This summer I will get the frames adonized. 

Ok that took longer than hoped. I tried to cold bend the aluminum tube but kept breaking them as the mandrels were too small. I had a local welder weld out the frames. Here they are installed. 

I just finished installing the Inferno heater yesterday.  It went pretty well, minor hiccup with one of the gear clamps.  The heater is a very tight fit in the dash, but it is a clean looking install.  I took it out for a little test drive and the heater is functioning.   For the doors I have...

Those uppers look alright, i definitely would have considered them had I seen them before I started to buy materials.  The AR poly carbonate sheet has arrived.  I will be getting into this the week of December 20th when I get some time away from my real job.  Good luck with your doors and...

OK, time will tell if this is a bad idea.  I am proceeding with building my own uppers for the can-am half doors to help close in the cab.  I have just build a template for the window and have ordered a sheet of Lexan MR-10 (abrasion resistant polycarbonate).  I will make the frames out of angle...

Hkb82 - have you made any headway on making uppers for your can-am half doors?  I am thinking about doing the same.  I was thinking something that can be removed easy for summer.