Recent content by ArcticHD8XTCab

Break in is 1000km. As far as running tracks, I run the LT360s but on much harder snow then what you would be using and most of the time run at 4500-4700rpm and 20-25km/h Its not fast with the tracks, but it is very torqy. I run in 4wd with rear dif lock. I wouldn't run in 2wd simply because the...

So I took this into our BRP guys here and apparently is the PPS sensor. At first I thought this was a throttle body sensor, but apparently its actually part of the gas pedal assembly. Supposedly its to prevent people from flooding the engine? Anway what I am told is the sensor has failed and is...

I posted about the locking doors when they first unvield the new Limiteds in 2022 1/2 . I was lucky enough to get the earlier part of the year and still go the old style doors. 

They are all the same for the tracks front and rear 1 inner and 1 outer for each track assembly 6011-2RS and 6010-2RS. 

They are all the same for the tracks front and rear 1 inner and 1 outer for each track assembly 6011-2RS and 6010-2RS. 

I have since done the other track bearings and did find the front right track had some play the left side not so much. The wear on them was not even by any means. That said I find the only way to really tell is have someone ride infront of you and if you see the track jitter left to right at...

Unfortunately I never did. Ended up with a Pro Limited instead as I could never confirm on the 6x6. Would be nice for Can-am to offer something for the 6x6 

I have 2 defenders. a 2019 HD8 XT Cab and a 2022 HD10 Pro LTD. However the 2022 Pro LTD does not seem to like the cold compared to the old HD8.  2019 HD8 XT Cab (on tracks)  Odyssey Battery PC1200  0W40 Winter Can-am Oil  Start no problem -30C to -40C 2022 HD10 Pro LTD (on tires) ...

A few things I keep in my machine when running tracks:  Rubber mallet  24"pinch bar  These are for breaking ice build up around the tracks and CV boots  Folding Shovel  Breaker Bar Spare Tire Small Toboggan  If your tracks come off or break you can put the...

I dont think the Apache 360LTs have changed since from the ones I have seen around here. So I belive it would be the same bearings. As far as the seal number on the tracks that did not fail I reused the seal. On the one that did fail, I had to buy the kit from Can-am. Not sure if there is a part...

If you a referring to this seal on the far right of the photo. I don't know the number. Can-am had it in the bearing kit. When I had a complete failure I had to replace it, however the other track I replaced the bearings I reused that back seal and the oring that was under the "Apache 360"...

Was looking around and could not find much for a bed cover or topper that would fit the Defender Pro Limited. I had seen a gentleman on Instagram @defenders.of.the.north built one. It seemed to be of aluminum which I do not have a welder for so I came up with a bolt together solutions that is...